Table of Contents
Advertisement
South Bridge Configuration
Press <Enter> and the following sub-menu appears:
- South Bridge Chipset Configuration -
GbE Controller
This item allows user to enable or disable the GbE (Gigabit Ethernet) controller.
GbE LAN Boot
This item allows user to enable or disable the onboard PXE ROM for second
boot.
GbE Wake Up From S5
This item allows user to enable or disable the GbE W ake Up From S5 function.
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Off]
[On]
[Last State]
USB 2.0 Controller Mode
Set to [Enabled] if you need to use any USB 2.0 device in the operating system
that does not support or have any USB 2.0 driver installed, such as DOS and
SCO Unix.
Onboard 1394 Device
This setting controls the onboard 1394 device.
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before
power failure or interrupt occurred.
BIOS Setup
4-19
Advertisement
Table of Contents
