Table of Contents
Advertisement
M S-6441 Barebone
IDE Configuration
Press <Enter> and the following sub-menu appears:
- IDE Configuration -
Mirrored IDER Configuration
This item allows user to enable or disable the IDER function.
SATA#1 Configuration
This item allows you to configurare IDE device mode.
[Compatible]
[Enhanced]
Configure SATA#1 as
This item allows you to configure SATA mode.
[IDE]
As serial ATA only.
[RAID] As SATA RAID mode Supporting RAID0,1,5,10.
[AHCI] If AHCI is chosen, it allows you to enable SATA Stagger Spinup
Support (not RAID mode) and take all hard disks on board as
master.
Primary / Secondary / Third / Fourth IDE Master / Slave
The global timer is the hardware timer that counts down to the power saving
modes. If the monitoring of the listed hardware peripheral or component is
enabled, they will awaken the system or reload the original count of global
timer when they are accessed.
4-8
If Compatible selected, Legacy IDE Channels will be
presented for configuration.
If Enhanced selected, "Configure SATA as" will be pre
sented for setup.
Advertisement
Table of Contents
