Husqvarna 225i Operator's Manual page 16

WARNING:
for this function to operate correctly. Speak
to your servicing dealer when you select
your chain oil.
• Use Husqvarna chain oil for maximum saw chain life
and to prevent negative effects on the environment.
If Husqvarna chain oil is not available, we
recommend you to use a standard chain oil.
• Use a chain oil with good adherence to the saw
chain.
• Use a chain oil with correct viscosity range that
agrees with the air temperature.
CAUTION:
0°C/32°F some chain oils become too
thick, which can cause damage to the oil
pump components.
• Use the recommended cutting equipment. Refer to
Accessories on page 36 .
• Remove the cap to the chain oil tank.
• Fill the chain oil tank with chain oil.
• Attach the cap carefully.
Note:
To see where the chain oil tank is on you
Introduction on page 2 .
product, refer to
LED indicator
3 LED lights are on
2 LED lights are on
1 LED light is on
1 LED light flashes
To charge the battery
Charge the battery if it is the first time that you use it. A
new battery is only 30% charged.
CAUTION:
Connect the battery charger
to a power outlet with the voltage and
frequency that is specified on the rating
plate.
The battery does not charge if the battery temperature is
more than 50 °C/122 °F.
16
Use the correct chain oil
In temperatures below
Battery state of charge
The battery is 76% - 100% charged.
The battery is 51% - 75% charged.
The battery is 26% - 50% charged.
The battery is 0% - 25% charged.
Battery
WARNING:
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Ambient temperature
Operation of the battery 5 °C-40 °C / 41 °F-104 °F
Charging of the battery 5 °C-40 °C / 41 °F-104 °F
Battery status
The display shows the state of charge and if there are
problems with the battery.
1. Connect the power cord to the battery charger.
Read and understand the
1860 - 001 - 23.09.2022