Husqvarna 225i Operator's Manual page 14

4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Apply tension to the saw chain. Refer to
Maintenance on page 25 for instructions.
9. Tighten the bar knob.
To assemble the guide bar and saw
chain (with bar bolt)
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
14
Always remove the battery
2. Loosen the bar nut and remove the drive sprocket
cover.
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Tighten the bar nut with your fingers.
9. Tighten the saw chain. Refer to
page 25 for instructions.
To install the battery charger on the
wall
CAUTION:
Do not use an electric
screwdriver to install the battery charger to
the wall. An electric screwdriver can cause
damage to the battery charger.
Maintenance on
1860 - 001 - 23.09.2022