MSI K8NNeo4 Platinum Series User Manual page 60

EPP M ode Select
The onboard parallel port is EPP Spec. compliant, so after the user chooses
the onboard parallel port with the EPP function, the following message will
be displayed on the screen: "EPP Mode Select." At this time either [EPP 1.7]
spec or [EPP 1.9] spec can be chosen.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard parallel
port with the ECP feature. After selecting it, the following message will
appear: "ECP Mode Use DMA." At this time, the user can choose between
DMA channel [3] or [1].
IDE Function Setup
Press <Enter> to enter the sub-menu and the following screen appears:
OnChip IDE Channel 0
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Choose [Enabled] to activate each channel separately.
Settings: [Enabled], [Disabled].
both support Ultra DMA/33, Ultra DMA/66 and Ultra DMA/100 select Auto to
enable BIOS support. The settings are: [Auto], [Disabled].
OnChip IDE Channel 1
The integrated peripheral controller contains an IDE interface with support
for two IDE channels. Choose [Enabled] to activate each channel separately.
Settings: [Enabled], [Disabled].
IDE DMA Transfer Access
This item is used to enable or disable the DMA transfer function of the IDE
Hard Drive. The settings are: [Enabled], [Disabled].
SATA1/SATA2 & SATA3/SATA4
This item is used to enable or disable onchip SATA controller. The settings
are: [Enabled], [Disabled].
BIOS Setup
3-17