Chassis Intrusion Switch Connector: Jci1 - MSI 848P-V2 Series Instruction Manual

IDE Connector: IDE1/IDE2
The mainboard has dual Ultra DMA 66/100 controller that provides PIO mode 0~4, Bus
Master, and Ultra DMA 66/100 function. You can connect up to four hard disk drives,
CD-ROM, 120MB Floppy and other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly.
MSI Reminds You...
If you install two hard disks on one cable, you must configure the second drive to Slave mode by
setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
Serial ATA Connectors controlled by Intel
The mainboard provides dual high-speed Serial ATA interface ports. The ports
st
supper 1 generation Serial ATA data rates of 150MB/s and are fully compliant
with Serial ATA 1.0 specifications. Each Serial ATA connector can connect to 1 hard disk device.
MSI Reminds You...
Please do not fold the serial ATA cable in a 90-degree angle, which will cause the loss of data
during transmission.
CD-In Connector: AUDIO2000
The connector is for CD-ROM audio connector.

Chassis Intrusion Switch Connector: JCI1

This connector is connected to a 2-pin chassis switch. JCI1 is
compliant with Intel
®
Front Panel I/O Connectivity Design Guide.
®
ICH5: SATA1/SATA2
L
GND
R
7