Power Saving Led Connector: Jgled1; Chassis Intrusion Switch Connector: Jci1 - MSI MS-6791 Manual

Power Saving Switch Connector: JSMI1
Attach a power saving switch to this connector. Pressing the switch
once will have the system enter the sleep state. Press any key to wake up the
system.

Power Saving LED Connector: JGLED1

This allows you to connect to a power saving LED. The LED will be lit when
the system enters the suspend mode.

Chassis Intrusion Switch Connector: JCI1

This connector is connected to a 2-pin chassis switch. If the chassis is opened,
the switch will be short connected. The system will record this status and
show a warning message on the screen. To clear the warning, you must enter
the BIOS utility and clear the record. JCI1 is compliant with Intel
I/O Connectivity Design Guide.
JCI1
1
JSMI1
Hardware Setup
®
Front Panel
Pin Signal
1 NC
2 Power
3 LED
1
JGLED1
CINTRU
GND
2-27