MSI 845E Neo-V User Manual page 55

MS-6566E ATX Mainboard
Re-Call VGA BIOS at S3 Resuming
Selecting [Enabled] allows BIOS to call VGA BIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an AGP driver to initialize
the VGA card. Therefore, if the AGP driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Power Management/APM
Setting to [Enabled] will activate an Advanced Power Management (APM) device to
enhance Max Saving mode and stop CPU internal clock. Settings: [Disabled], [Enabled].
Power Button Function
This feature sets the function of the power button. Settings are:
[On/Off]
[Suspend]
Restore on AC/Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Power Off]
[Power On]
[Last State]
Set Monitor Events
Press <Enter> and the following sub-menu appears.
MIDI Ports, Primary/Secondary Master/Slave IDE
These items specify if the BIOS will monitor the activity of the specified hard-
ware peripheral or component. If set to [Monitor], any activity detected on the
specified hardware peripheral or component will wake up the system or pre-
vent the system from entering the power saving modes. Settings: [Monitor],
[Ignore].
Set WakeUp Events
Press <Enter> and the following sub-menu appears.
3-14
The power button functions as normal power off button.
When you press the power button, the computer enters
the suspend/sleep mode, but if the button is pressed for
more than four seconds, the computer is turned off.
Leaves the computer in the power off state.
Leaves the computer in the power on state.
Restores the system to the previous status before power
failure or interrupt occurred.