Using Your Radio - Cobra LI 6000WXC Owner's Manual

Using Your Radio

Introduction
For charging microTALK
Insert Radio(s)
charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert round connector of 120 volt adapter
into jack on back of charger.
3. Plug 120 volt adapter into electrical outlet.
If charging light is not on, check position of radio. Radio should be
upright. The charge indicator light will stay on as long as the radio
is in the charging well and the battery pack is charging. After the
battery pack is fully charged, the charge indicator light will turn off.
It normally takes about 15 hours to fully recharge battery pack.
Battery pack will not be damaged if they stay in the charging well
longer than that.
Each port can charge one radio. Uses 120 Volt adapter.
Cobra recommends your radio is turned off while being charged.
The Basics to Get You Started
Your microTALK
To get started, simply:
1. Press and hold the Power button to turn
on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to
the same channel/privacy code
to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
English
2
® radio(s) in desktop
® radio is easy to use.
Operation
Introduction
Turning on Your microTALK
On/Off Power
To turn on your radio:
– Press and hold the Power button until you
hear a series of audible tones indicating the
radio is on.
Your microTALK
mode, ready to receive transmissions. The radio
is always in Standby mode, except when the
Talk, Call, Mode or Power buttons are pressed.
Battery Low
Battery Low
When battery power is low, the Battery Low icon
will blink. Your batteries should be recharged.
Auto Battery Save
Battery Save Mode
Your microTALK
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to Battery Save mode and
the Power Saver icon will flash in the display.
This will not affect the radio's ability to receive
incoming transmissions.
Communicating with Another Person
Talk Button
To talk to another person:
1. Press and hold the Talk button.
2. With the microphone about two inches
(five cm) from your mouth, speak in a
Two Inches (five
cm) from Mouth normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to
the same channel/privacy code
to communicate.
Customer Assistance Warranty
® Radio
® radio is now in Standby
® radio has a unique circuit
Nothing Comes Close to a Cobra
•
•
•
•
® 3