Cobra LI 6000WXC Owner's Manual page 15

Mode Functions
Operation
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that
memory location.
b. Your radio will remain on that memory location and return to
Standby mode. Press the Channel Up or Channel Down button
to resume scanning memory locations.
c. After 10 seconds of inactivity, unit starts scan again.
If you press the Talk button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or memory location on which, during
scanning, you last received a transmission.
b. Press the Mode button to proceed to other functions.
c. Press the Lock/Enter button to return to Standby mode
on the channel/privacy code that was displayed before you
entered mode functions or the memory location on which,
during scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 16
to de-program a memory location.)
English
22
Operation
Introduction
VibrAlert ® and Call Alert
Your microTALK ® radio can alert you to incoming signals by
sounding an audible call tone, by vibrating silently or both.
To change call settings:
Mode Button
1. Press the Mode button
until the Call Setting icon
flashes on the display.
The current setting ("01"
Channel Buttons
vibrate + ring, "02" vibrate
only or "03" ring only)
is displayed.
2. Press the Channel Up or
Channel Down button to
change the call setting.
3. Choose one of the following:
a. Press the Mode button
to enter the new setting
and proceed to other functions.
b. Press the Lock/Enter button to enter the
new setting and return to Standby mode.
Customer Assistance Warranty
VibrAlert + Ring
®
VibrAlert Only
®
Ring Only
Nothing Comes Close to a Cobra
•
® 23