20/24
Control panels CP1 and CP2 | Commissioning
Bosch Rexroth AG, RE 95259-01-B/2021-11-09
8 Commissioning
During all work for commissioning the control panel, observe the general safety
instructions and intended use detailed in chapter 2 "Safety instructions"
from page 7 on.
▶ When commissioning the control panel, the machine may pose unforeseen
hazards. Before commissioning the system, you must therefore ensure that the
vehicle and the hydraulic system are in a safe condition.
▶ Commission the machine and check the correct functioning of the control panel.
9 Operation
This product is a component which requires no settings or changes during
operation. For this reason, this chapter of the manual does not contain any
information on adjustment options. Use the product only within the performance
range specified in the technical data.