Page 2
Connecting the FS-1-WL to the GS-1 Turn both the GS-1 and the FS-1-WL on, and place them near each other. Press the [Bluetooth] button on the GS-1. The unit enters pairing mode, and the Bluetooth indicator on the GS-1 rapidly blinks blue.
Page 3
GS-1, or when turning off the power while the Bluetooth indicator is blinking white (not connected), or when doing a factory reset of the FS-1-WL, the unit does not pair automatically. In this case, you must start from step 1 to...
Page 4
Connect the GS-1 and the FS-1-WL, and then connect the GS-1 and the GS-1 Editor. Turn both the GS-1 and the FS-1-WL on, and place them near each other. Press the [Bluetooth] button on the GS-1.
Page 5
NOTE ¹ You cannot use the GS-1 Editor and the FS-1-WL Editor at the same time. ¹ Do not tap “FS-1-WL+” in GS-1 Editor app while connecting. The FS-1-WL remembers the information for the last Bluetooth device to which it was connected.
Page 6
* The GS-1 and FS-1-WL are connected automatically next time they are restarted. To connect the GS-1 Editor you must perform steps 4 and 5 each time. * If the devices do not pair after one minute has passed, pairing mode is automatically canceled.
Page 7
When FS-1-WL and GS-1 set to their default values, the FS-1-WL controls correspond to the following parameters on GS-1. * To operate GS-1 with FS-1-WL, CC# of FS-1-WL and CC# of GS-1 must match. GS-1 Editor default setting screen FS-1-WL...