Miscellaneous Control - JETWAY 865GF User Manual

CPUFAN/SYSFAN Temp1/Temp2 Value
This item allow users setting the temperature value of CPU/SYSTEM for FAN speed
controller change the FAN speed the setting are 30°C∼100°C.
CPUFAN/SYSFAN Speed below Temp1/Temp2
This item allow the FAN work in 50%, 60%, 70%, 80%, 90%, 100% of full speed when the
CPU/SYSTEM temperature below Temp1/Temp2.
Current CPU Temperature/Current System Temp/Current CPUFAN, SYSFAN Speed/
Vcore/Vdd/3.3V
This will show the CPU/FAN/System voltage chart and FAN Speed.

3-11 Miscellaneous Control

This section is for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2004 Award Software
CPU Clock Ratio
Auto Detect PCI Clk
Spread Spectrum
** Current Host Clock is
HOST Clock at Next Boot is
** Current DRAM Clock is
DRAM Clock at Next Boot is
CPU Vcore Select
VDIMM Select
VCC1.5 Select
Flash Part Write Protect
↑ ↓ → ←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Auto Detect PCI Clk
This item allows you to enable/disable auto detect PCI Clock.
The settings are: Enabled, Disabled.
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host/PCI Clock at Next Boot
This item allows you to select CPU frequency step by step increasing.
The choice are: 400MHz CPU----100MHz~350MHz, 533MHz CPU---133MHz~350MHz
800MHz CPU---200MHz~350MHz
DRAM Clock at Next Boot is
This item allows you select the DRAM Clock for DDR266/DDR333/DDR400. The setting are:
DDR266 for P4/400MHz CPU, DDR266/DDR333 for P4/533MHz CPU, DDR266/DDR333
/DDR400 for P4/800MHz CPU
Flash Part Write Protect
This item allows you protect your BIOS chip from Virus destroy data. When Flash BIOS you
have Disabled this item.
Miscellaneous Control
8 X
Enabled
Disabled
100
By SPD
Default
2.60V(Default)
1.55V(Default)
Enabled
F6:Optimized Defaults
33
Item Help
Menu Level >
F1:General Help
F7:Standard Defaults