JETWAY 865GF User Manual page 16

(7) Audio Connector : CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC .
Line-out (Green):Audio output to speaker for Front Speaker output in 6-Channel
Line-in (Blue):
MIC (Pink):
(8) VGA Connector (15-pin D-Sub) Connector: VGA
VGA is the 15-pin D-Subminiature female connector for display monitor.
(9) Serial Port1 COM1: COM1
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(11) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(12) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
Audio input to sound chip or REAR Speaker output in 6-Channel
Microphone Connector or Center/Base Speaker output in 6-Channel
PS/2
Mouse
PS/2
Keyboard
Pin 1
PRINT
COM1 VGA USB1
FDD
Floppy Drive Connector
IDE1
Pin 1
Primary IDE Connector
13
LAN
MIC
LINE-IN
LINE-OUT
USB