Power Saving Mode - Cateye Air GPS Instruction Manual

Power-saving mode
The Air GPS enters power-saving mode if no speed is measured and no button is pressed
for 10 minutes.
The power-saving mode functions according to the display previously displayed.
•
Standby (before start of measurement)
When the Air GPS enters power-saving mode, it is automatically turned off.
When left for 10 min
Standby
* It will automatically power off in ten minutes if MODE or
to start measurement.
•
During measurement or when measurement is paused
When the Air GPS enters power-saving mode, it displays the power-saving screen.
If this state continues for 2 hours, the Air GPS is automatically turned off after finishing
measurement and saving measurement results.
Measurement in
progress
Paused
* GPS signals are not received in power-saving mode. The Air GPS returns to the
previous screen and resumes GPS search when any button is pressed.
* If the Air GPS enters power-saving mode during measurement, it returns to the
measurement screen with just detection of vibration and resumes GPS search.
MODE
Detection of vibration or
operation of any button
When left for
10 min
Power-saving
screen
MODE
Operation of any button
14
Starting measurement
Finishing
measurement/
Power OFF
(POWER) is not pressed
When left
for 2 hours
Finishing
measurement/
Power OFF
Cover,
Introduction
1
Setup
2
Mounting on a
bicycle
3
Starting
measurement
Starting
measurement
6/6
4
Measurement
results
5
SET
Changing settings/
Using sensors
Frequently
Asked
Questions
Appendix