Chapter 3: Product Overview; Front Panel; Bottom Panel; Top Panel - Linksys WAP200E User Manual

Chapter 
Chapter :
Product Overvew

Front Panel

The Access Point's LEDs, where information about network
activity is displayed, are located on the front panel.
Front Panel
Power (Green) The Power LED lights up when
the Access Point is powered on.
Wred (Green) The Wired LED lights up when
the Access Point is successfully connected to a
device through the Ethernet network port. If the
Wired LED is flashing, the Access Point is actively
sending to or receiving data from one of the
devices over the Ethernet network port.
Wreless (Green) The Wireless LED lights up
when the wireless module is active on the Access
Point. If the Wireless LED is flashing, the Access
Point is actively sending to or receiving data from
a wireless device.
Wreless-G Exteror Access Pont wth Power Over Ethernet

Bottom Panel

The Ethernet network port is located on the bottom panel
of the Access Point.
Bottom Panel
Ethernet network port
port connects to Ethernet network devices, such
as a switch or router. The Access Point is powered
using Power Over Ethernet. If the switch or router
doesn't support Power Over Ethernet, then a
Power Over Ethernet Injector must be installed.

Top Panel

The antenna port is located on the top panel of the Access
Point.
Top Panel
Antenna Port The Access Point has built-in,
1x2 MIMO 9dBi directional antennas. It also has
a reverse polarity female N-type antenna port
for an optional, high-gain external antenna
such as the HGA9N. One of the two internal
antennas will be disabled automatically when
an external antenna is connected.
Product Overview
The Ethernet network