Chapter 5: Connecting The Wireless-N Access Point; Overview; Connection; Placement Options - Linksys WAP4410N User Manual

Connecting the Wireless-N Access Point

Overview

This chapter explains how to place and connect the Access Point.
Depending on your application, you might want to set up the device first before mounting the
device.

Connection

1. Connect your Ethernet network cable to your network router or switch. Then connect the
other end of the network cable to the Access Point's Ethernet port.
2. If you are using Power Over Ethernet (POE), proceed to the following section, "Placement
Options. "
If you are not using POE, then connect the included power adapter to the Access Point's
Power port. Then plug the power adapter into an electrical outlet. The LEDs on the front
panel will light up as soon as the Access Point powers on.

Placement Options

There are three ways to place the Wireless-N Access Point. The first way is to place it horizontally
on a surface, so it sits on its four rubber feet. The second way is to stand the Access Point
vertically on a surface. The third way is to mount it on a wall. The stand and wall-mount options
are explained in further detail below.
WAP4410N User Guide
Connecting the Wireless-N Access Point
Overview
9