Figure 4-3: Enter A Password; Figure 4-4: Ip Settings; Figure 4-5: Date/Time Settings - Linksys NSLU2 User Manual

Network Storage Link for USB 2.0 Disk Drives
4. Next, you will need to enter a password. The default password is admin. After entering the password, click
the OK button.
5. The next screen that appears has the Storage Link 's IP settings. Select the Automatically obtain an IP
address (DHCP) setting if you already have a DHCP server setting IP Addresses on your network devices. If
you select Set IP configuration manually, you will set the Storage Link 's IP Address and network
information. Enter the following information.
• IP Address. Enter the Storage Link 's IP Address here, making sure that it is on the same LAN segment as
the PC running the Setup Wizard.
• IP Mask. Enter the Subnet Mask in the fields. It must match the other devices on your network. It is set by
default to 255.255.255.0.
• Gateway. This value is left blank by default. If you have a router on your network, however, enter its IP
Address here.
Click the Next button to proceed or the Back button to return to the previous screen.
6. From the next screen, you can change the time and date on the Storage Link .
• Time Zone. Select your local time zone from the drop-down menu here.
• Date. Set your current date here.
• Time. Set your current time here.
Click the Next button to proceed or the Back button to return to the previous screen.
Chapter 4: Setting Up the Storage Link
Setup Wizard

Figure 4-3: Enter a Password

Figure 4-4: IP Settings

Figure 4-5: Date/Time Settings

10