Chapter 2: Getting To Know The Storage Link; The Back Panel; Figure 2-1: Back Panel - Linksys NSLU2 User Manual

Network Storage Link for USB 2.0 Disk Drives

Chapter 2: Getting to Know the Storage Link

The Back Panel

The Storage Link's ports and connectors are located on the back panel.
Ethernet This LAN (Local Area Network) port connects to Ethernet network devices, such as
a switch or router.
Disk 2 Insert your USB Flash Drive (USB key) or USB disk here.
Disk 1 Connect your USB hard drive here. (Flash drives will not be recognized.)
Reset Button This button has 2 functions:
If the Network Storage Link's IP Address is lost, press and hold this button for two
seconds. The IP Address will be set to the default value of 192.168.1.77 and it will
beep once to indicate the reset has occurred.
If the Network Storage Link's password is lost, press and hold this button for 10
seconds. The password will then be set to the default value of "admin", and the
Network Storage Link will beep again.
Power Connect the power adapter here.
Important: Resetting the Network Storage Link will erase all of your
settings and replace them with the factory defaults. Do not reset the
Network Storage Link if you want to retain the settings.
Chapter 2: Getting to Know the Storage Link
The Back Panel

Figure 2-1: Back Panel

4