Table of Contents
Advertisement
g The [PROJECTOR SETUP] menu → [POWER MANAGEMENT] → [NO SIGNAL LIGHTS-OUT]
f The fan will rotate to cool the projector while the no signal lights-out function is operating and the light source is turned off. Also, the power
indicator <ON (G)/STANDBY (R)> blinks slowly in green.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], the following are the conditions to turn the light source back on
again from the condition that the light source has turned off by this function.
g When the signal is input
g When on-screen display such as menu screen (OSD) or input guide, a test pattern, or a warning message is displayed
g When the <POWER ON> button is pressed
g When the operation to disable the shutter function (shutter: opened) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The no signal lights-out function is disabled in following case.
g When [BACK COLOR] is set to [DEFAULT LOGO] or [USER LOGO], and the Panasonic logo or the image registered by the user is
displayed in the projected image
[NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a
certain period of time. The time before switching to standby can be set.
1)
Press as to select [NO SIGNAL SETTING].
2)
Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3)
Press as to select [NO SIGNAL SHUT-OFF].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]
Note
f The [NO SIGNAL SHUT-OFF] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [POWER MANAGEMENT] → [NO SIGNAL SHUT-OFF]
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1)
Press as to select [INITIAL STARTUP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1)
Press as to select [STARTUP INPUT SELECT].
2)
Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3)
Press asqw to select the input, and press the <ENTER> button.
[LAST USED]
[HDMI1]
[HDMI2]
[DisplayPort]
[SDI [SLOT]]
*1
[DIGITAL LINK [SLOT]]
[PressIT [SLOT]]
192 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the No signal shut-off function.
Sets the time in increments of 10 minutes.
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
Starts up the projector in standby.
Starts projecting immediately.
Keeps the input selected last.
Sets the input to HDMI1.
Sets the input to HDMI2.
Sets the input to DisplayPort.
Sets the input to SDI.
Sets the input to DIGITAL LINK.
*2
Sets the input to PressIT.
*3
Advertisement
Table of Contents
