Table of Contents
Advertisement
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f The [CALIBRATION MESSAGE] setting will be reflected at the time when the item is switched using qw .
f The [CALIBRATION MESSAGE] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CALIBRATION MESSAGE]
Brightness control adjustment procedure example
The steps exemplify an adjustment to link the brightness and white balance of eight projectors connected in a
network.
1)
Connect all projectors to the switching hub using LAN cables. ( x page 149)
2)
Switch on all projectors and start projection.
3)
Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [OFF], and select [APPLY], and then
press the <ENTER> button.
4)
Set [OPERATING MODE] of each projector to the same setting. ( x page 106)
5)
Set the administrator account, [SUBNET MASK], and [IP ADDRESS] of each projector.
f Set the administrator account (user name and password) of all linked projectors to the same setting.
f To be able to communicate over the network, set the same value in [SUBNET MASK] for all projectors and
set a different value in [IP ADDRESS] for each projector.
6)
Wait for at least eight minutes after projection has started until the light source brightness becomes
steady.
7)
Set all items in the [PICTURE] menu of all projectors to the same values.
8)
Adjust [COLOR MATCHING] to match colors.
9)
Display the internal test pattern "All white" in all projectors.
10) Set [LIGHT OUTPUT] of all projectors to 100 % or the maximum value that can be set.
f Depending on the [OPERATING MODE] settings, [LIGHT OUTPUT] may not be able to be set to 100 %.
11) Set [LIGHT OUTPUT] of the projector with the least brightness to 90 % or 10 % lower than the
maximum value that can be set.
12) Adjust [LIGHT OUTPUT] of each projector.
f Adjust [LIGHT OUTPUT] of all the other projectors so that the brightness will be the same as the projector
with the least brightness.
13) Set [CONSTANT MODE] of [BRIGHTNESS CONTROL SETUP] to [AUTO], and [LINK] to [GROUP A] in
all projectors.
14) Select [APPLY] of [BRIGHTNESS CONTROL SETUP] and press the <ENTER> button in all projectors.
f Automatic correction by the brightness control function starts.
Note
f Automatic correction is performed whenever the light source lights up by switching on/off the projector, etc.
f When the variation in brightness or color has increased due to aging of the light source, or when the light source is replaced, reset
[BRIGHTNESS CONTROL SETUP].
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1)
Press as to select [INITIAL STARTUP].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays the time to complete the measurement while the brightness and color of the light source are
measured by the brightness sensor.
Does not display a message during the measurement.
ENGLISH - 115
Advertisement
Table of Contents
