Table of Contents
Advertisement
f When the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] → [MODE] is set to [SUB], value of [FRAME DELAY] on the
projector set as [MAIN] limits the setting range of [FRAME DELAY] on this projector. If value that exceeds the limit, the value will be
displayed in yellow and will not be reflected on the projector.
g Setting that results in a minus value when added with the [FRAME DELAY] setting value of the projector set as [MAIN] cannot be made.
g Setting that exceeds +100.00 ms when added with the [FRAME DELAY] setting value of the projector set as [MAIN] cannot be made.
[FRAME LOCK]
(PT-RZ24K and PT-RZ17K only)
Set this function to display the image in 3D when the vertical scanning frequency of the signal is 25 Hz, 50 Hz,
and 103.9 Hz.
1)
Press as to select [FRAME LOCK].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f [FRAME LOCK] is not displayed when a signal with the vertical scanning frequency other than the above is input or 2D images are
displayed.
f The image may flicker when [FRAME LOCK] is set to [ON].
f The displayed image may look discontinuous when [FRAME LOCK] is set to [OFF].
[QUAD PIXEL DRIVE]
(PT-RQ25K and PT-RQ18K only)
Enable/disable the QUAD PIXEL DRIVE function to enhance the resolution of the projected image.
1)
Press as to select [QUAD PIXEL DRIVE].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f [QUAD PIXEL DRIVE] is fixed to [ON] in the following cases.
g When the [POSITION] menu → [GEOMETRY] is set to anything other than [OFF]
g When [CUSTOM MASKING] in [BLANKING] is set to anything other than [OFF] ([PC-1], [PC-2], [PC-3])
f [QUAD PIXEL DRIVE] is set to [OFF] when the focus test pattern or the cross hatch test pattern is displayed using the [TEST PATTERN]
menu.
To enable the QUAD PIXEL DRIVE function while displaying the focus test pattern or the cross hatch test pattern, set [QUAD PIXEL DRIVE]
to [ON] again while displaying the focus pattern or the cross hatch test pattern.
[RASTER POSITION]
This function will allow the position of the image to move within the displayable area arbitrarily when the input
image is not using the whole displayable area.
1)
Press as to select [RASTER POSITION].
2)
Press the <ENTER> button.
f The [RASTER POSITION] screen is displayed.
3)
Press asqw to adjust the position.
132 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Decreases the flickering of the displayed image.
Synchronizes the displayed image to the vertical scanning frequency of the input signal.
Enables the QUAD PIXEL DRIVE function.
Disables the QUAD PIXEL DRIVE function.
Advertisement
Table of Contents
