Introduction - Cobra ESD-9220 WX Operating Instructions Manual

Introduction

and Strobe Alert™
Use of this product is not
intended to, and does not ensure
that the motorist and any
passenger will not be involved in
a traffic accident. It is only
intended to alert the motorist
that an emergency or service
vehicle equipped with a CODE 3,
Strobe (Opticom* or Tomar
Preemption System) or Cobra®
Safety Alert® Transmitter is in the
area as defined by the range of
the product. Please call your local
Fire/Police department to verify if
coverage exists in your area.
Motorists are expected to
exercise all due caution while
using this product, and to
observe and follow all applicable
traffic laws. Operators of
emergency or service vehicles are
also expected to exercise all due
caution while using this product,
and to observe and follow all
applicable traffic laws.
*Opticom is a registered trademark
of 3M Corporation
1.
2.
3.
Introduction
Congratulations! You have just purchased the
most sophisticated RADAR/LASER DETECTOR
available today. This booklet contains instructions
and information designed so that you will be able
to understand how the Cobra® ESD-9220 WX
works and how radar and (LIDAR) laser are used.
Enjoy your Cobra® ESD-9220 WX Radar/Laser
Detector and drive safely.
Federal Law Governing Use of
Radar Detectors
It is not against Federal Law to receive radar
transmissions on your COBRA® Radar Detector.
The Communications Act of 1934 guarantees
your right to receive radio transmissions on
any frequency. Local laws that contravene the
Communications Act of 1934, while illegal, may
be enforced by your local law enforcement
officials until and unless they are prohibited from
doing so by Federal Court action.
WARNING: Before leaving your car, make sure
that you conceal your radar detector. This will
reduce the possibility of break-in and theft of
your unit.
Included with your ESD-9220 WX
1. Windshield Bracket
2. Hook and Loop Material
3. Power Cord
A1