Table of Contents
Advertisement
9.12.4. Slide Cam
1. Perform the step"9.12.3.Pulley Gear,Belt and Mid Gear".
2. Remove the sheet.
3. Open the connector lock,and disconnect the 4 FFCs.
4. Remove the Screw (A),Heat Sink and Drive P.C.B..
Caution:
Though the Drive P.C.B. is not supplied as replace-
ment parts,it must be removed for after disassem-
bling.
5. Remove the 2 Dampers.
6. Open the connector lock,and disconnect the OPU FFC.
7. Pull the Slide Cam to the right side.
8. Remove the Traverse Base Ass'y with spreading the 2
Hooks to the direction of arrows.
9. Remove the Slide Cam.
9.12.5. Drive Gear and Loading Motor
1. Perform the step"9.12.4.Slide Cam".
2. Remove the Drive Gear.
3. Remove the 2 soldering points.
68
Hide quick links:
Advertisement
Table of Contents
