Mode Name
Drive application check
Checking whether the drive is applicable
drive or not.
HDD READ SEEK
Inspecting seek time of HDD to inspect
Inspection
performance .
Item
Description
FL Display
At start
The [*] sign is added every
approx.10 seconds while inspect-
ing.
Two digits on the right side are the
progress level of the inspection
(The unit is %).
Example on the way of inspection:
When HDD is OK after inspection:
(NG is displayed when error is
excluding 0)
(Transfer rate is calculated from the
AV scanning result, and when it is
less than 35Mbps, NG is displayed.)
$: [X] is displayed when seek time is
over 270msec., there is error or
transfer rate is NG.
Position at $ is space when
excluding those.
##: Number of data of over
100msec. and less than 270msec.
When it is over 100, [99] is
displayed.
When the number is less than 5, we
judge it normal.
46
Key Operation
(Remote controller key)
Press [0] [3] in service mode.
Press [3] [1] in service mode.
* When canceling the inspection
mode while executing, do "forced
power-off".
Method: Press [POWER] key on the
main unit more than 4 seconds.