Linksys SVIEW04 User Manual page 9

• Auto Scan Mode
Auto Scan automatically switches among all the active CPU Ports of all the 4-
Station CPU Switches in the installation at regular intervals, allowing you to
monitor their activity automatically. The length of the interval is determined by
DIP Switches 1 and 2 on the Primary unit, as follows:
Time Interval
5 Seconds
10 Seconds
20 Seconds
40 Seconds
Use the following method for Auto Scan Mode:
1. Invoke HotKey navigation as shown in Port Selection. [CTRL + ALT +
SHIFT]
2. Type "0" (zero).
3. Press the Enter key.
To exit Auto Scan Mode, press the Spacebar. The port active when exiting
Auto Scan Mode will remain active.
NOTE: While using Auto Scan Mode, the con-
sole will not function. You must exit Auto Scan
Mode in order to use the console again.
12
ProConnect
DIP Switch 1 DIP Switch 2
ON ON
OFF ON
ON OFF
OFF OFF
® Series
ProConnect
• Last/Next Mode
Last/Next Mode enables you to easily switch from the currently active com-
puter to the previous or next available computer in the installation. There are
two methods of invoking Last/Next Mode: Quick Mode and Basic Mode.
A method can be selected by using DIP Switch 4 on the rear panel of the First
Stage unit. To enable Quick Mode, set the DIP Switch ON. To enable Basic
Mode, set the DIP Switch OFF.
With Quick Mode enabled, Last/Next Mode is always available and need not
be invoked, which is necessary in Basic Mode. To use Quick Mode, press the
left CTRL key twice to switch to the previous available computer in the instal-
lation or the right CTRL key twice to switch to the next available computer in
the installation.
While Quick Mode does allow for greater convenience, it may conflict with one
of the programs running on a computer.
With Basic Mode, you must first invoke the function by:
1. Pressing and simultaneously releasing either [CTRL + ALT + SHIFT] or
[LEFT CTRL + RIGHT CTRL].
2. Typing "9" and then the ENTER key.
Once invoked, press the left SHIFT key twice to switch to the previous avail-
able computer in the installation or the right SHIFT key twice to switch to the
next available computer in the installation.
While Basic Mode is invoked, the console will not function. You must exit
Basic Mode by pressing the SPACEBAR in order to be able to use the console.
® 4-Station CPU Switch
13