Linksys EF1324 User Manual page 57

DVMRP Routing Table
The DVMRP Routing Table shows the routes for the Distance-
Vector Multicast Routing Protocol.
• Source Address - The IP subnetwork at the root of the multicast
delivery tree. This subnetwork contains a known multicast source.
• Mask - Subnet mask that is used for the source address. This mask
identifies the host address bits used for routing to specific subnets.
• Upstream Nbr - The IP address of the network device immediately
upstream for this multicast delivery tree.
• Interface - The IP interface on this Switch that connects to the
upstream neighbor.
• Metric - The metric for this interface used to calculate distance
vectors.
• Up Time - The time elapsed since this entry was created.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the next
page. To display a specific page, set the page number in the Page field and then
press Apply.
106
Instant EtherFast Series
®
EtherFast Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch
®
DVMRP Neighbor Table
The DVMRP Neighbor Table shows information about the neighbors
used for the Distance-Vector Multicast Routing Protocol.
• Interface - The IP interface on this Switch that connects to the
upstream neighbor.
• Neighbor Address - The IP address of the network device
immediately upstream for this multicast delivery tree.
• UpTime- The time since this device last became a DVMRP neigh-
bor to this Switch.
• ExpireTime - The time remaining before this entry will be aged
out.
• Ver - The neighboring router's DVMRP version number.
• RcvRoute - The total number of routes received in valid DVMRP
packets from this neighbor. This can be used to diagnose problems
such as unicast route injection, as well as giving an indication of
the level of DVMRP route exchange activity.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the next
page. To display a specific page, set the page number in the Page field and then
press Apply.
107