Linksys EF1324 User Manual page 48

• Undersize Frames - The total number of frames received that were less
than 64 octets long (excluding framing bits, but including FCS octets)
and were otherwise well formed.
• Oversize Frames - The total number of frames received that were longer
than 1518 octets long (excluding framing bits, but including FCS octets)
and were otherwise well formed.
• Fragments - The number of outbound packets that could not be trans-
mitted because of errors.
• Jabbers - The total number of frames received that were longer than
1518 octets long (excluding framing bits, but including FCS octets) and
had either an RCS or alignment error.
• Collisions- The best estimate of the total number of collisions on this
Ethernet segment.
• 64 Byte Frames - The total number of frames (including bad packets)
received and transmitted that were 64 octets in length (excluding framing
bits, but including FCS octets).
• 65-127 Byte Frames - The total number of frames (including bad pack-
ets) received and transmitted where the number of octets fall within the
specified range (excluding framing bits, but including FCS octets).
• 128-255 Byte Frames - The total number of frames (including bad pac-
ets) received and transmitted where the number of octets fall within the
specified range (excluding framing bits, but including FCS octets).
• 256-511 Byte Frames - The total number of frames (including bad pack-
ets) received and transmitted where the number of octets fall within the
specified range (excluding framing bits, but including FCS octets).
• 512-1023 Byte Frames - The total number of frames (including bad
packets) received and transmitted where the number of octets fall within
the specified range (excluding framing bits, but including FCS octets).
• 1024-1518 Byte Frames - The total number of frames (including bad
packets) received and transmitted where the number of octets fall within
the specified range (excluding framing bits, but including FCS octets).
88
Instant EtherFast Series
®
EtherFast Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch
®
• 1519-1536 Byte Frames - The total number of frames (including bad
packets) received and transmitted where the number of octets fall within
the specified range (excluding framing bits, but including FCS octets).
Select Apply to make changes. Select Refresh to refresh the statistics. Select
OK to return to the previous panel. Select Reset to reset a specific statistic.
Select Reset All to reset the all statistics. Select Prev Port to view the previous
port. Select Next Port to view the next port. To display a specific port, set the
port number in the Port field and then press Apply.
Layer 2 Address Table
When you select Layer 2 Address Table from the Network Monitor Menu, you
will see a screen that allows you to select the Unicast Address Table. This con-
tains the MAC addresses associated with each port (that is, the source port
associated with the address).
• Address - The MAC address of a node seen on this Switch.
• Port - The port whose address table includes this MAC address.
Select Apply to make changes. Select OK to return to the previous panel.
Select Prev Page to view the previous page. Select Next Page to view the next
page. To display a specific page, set the page number in the Page field and then
press Apply.
89