Table of Contents
Advertisement
Wiring
4-5-2
Wiring RESET Signal and External Input Signal
I/O Solderless Terminal
4-14
2
RESET
input
The I/O terminals use M3 set screws. The following type of solderless
terminal can be connected to these terminals.
Tighten each screw to a torque of approximately 6 kgf • cm.
Note
1.Make sure that the input voltage does not exceed a maximum
permissible input voltage of 26.4 V, otherwise the Controller may
malfunction.
2.Separate power lines and high-tension lines from the input line in order
to protect the input line from noise interference.
IN1 IN2
24 VDC
6.5 max.
M3
Section 4-4
2
IN2
24 VDC
input
Advertisement
Table of Contents
