Ready Hex; Reattach <Device; Release Surface L - Lexmark W820n User Manual

Ready Hex

What this message means:
The printer is in Hex Trace mode and is ready to receive and process print jobs.
What you can do:
•
Send a job to print. All data sent to the printer is printed in hexadecimal and character
representation. Control strings are printed, not executed.
•
Turn the printer off and then on to exit Hex Trace mode and return to Ready status.
Reattach
<device>
What this message means:
The specified device, the multipurpose feeder or the envelope feeder, is either not fully
connected to the printer or is experiencing a hardware failure.
What you can do:
•
Reestablish communication by removing the specified device and reattaching it to the printer.
•
If hardware fails, turn the printer off and back on. If the error recurs, turn the printer off, remove
the specified device, and call for service.
See also:
Setup Guide ;
Calling for service

Release Surface L

What this message means:
Surface L, the green tab located between the two finisher bins, is up.
What you can do:
Release Surface L to clear the message. Look for a label on the printer to help you locate
Surface L.
See also:
Message maps
293