Installing A Memory Card - Lexmark W812 Setup Manual

memory card
Note:
Some memory options offered for
other Lexmark printers cannot be used
with your printer. Refer to the
Publications CD for memory
specifications.
Warning!
Memory cards are easily
damaged by static electricity. Touch
something metal on the printer before
you touch a card.
What do I do next?
Task
Install a firmware card
Install an option card
Reinstall the system board access panel
Installing a
Install memory, firmware, or option cards
Follow the instructions in this section to
install either a printer memory card or a
flash memory card.
The system board has two connectors
for optional memory cards. You can
install any combination of printer
memory and flash memory cards.
However, the printer only recognizes one
flash memory card at a time.
1
Remove the system board access
panel (see page 25).
2
Unpack the memory card.
Avoid touching the connection
points along the edge of the card.
Save the packaging.
3
Push open the latches on both
ends of the memory connector
you want to use.
4
Align the notches on the bottom of
the card with the notches on the
connector.
5
Push the memory card firmly into
the connector until the latches on
either end of the connector snap
into place.
It may require some force to fully
seat the card.
6
Make sure each latch fits over the
notch on the end of the card.
Go to page...
28
30
32
27