Attaching A New Operator Panel Overlay - Lexmark Optra E312 User Manual

Troubleshooting Tips
Problem:
The operator panel lights do not
come on when the printer is turned
on.
Attaching a new
operator panel
1
2
3
4
What to do:
• Make sure the power cord is firmly plugged in at the back of the printer
and at the wall outlet.
If you have a non-English overlay sheet in your printer
box and wish to use it, peel it off and place it over the
overlay currently on your printer.
overlay
Turn the printer off.
Plug one end of the power cord into the power
cord connector on the back of the printer and
the other end into a properly grounded wall
outlet.
Turn on the printer.
As the printer powers up, each operator panel light
turns on and off, starting with Press Button and
ending with the Ready light. If this does not
happen, see
Printing problems
When the Data light stops blinking and Ready
is the only light on, briefly press the operator
panel button.
A test page listing your printer model and default
settings should print out. If it doesn't, check
.
problems

Attaching a new operator panel overlay

.
Printing
13