Installing A Firmware Card - Lexmark C912 Setup Manual

Installing a firmware card
Note:
Firmware cards designed for other Lexmark
printers may not work with your printer.
Warning:
Firmware cards are easily damaged by static
electricity. Touch something metal, such as the printer
frame, before you touch a card.
Alignment pins
System board holes
Install memory and option cards
If an option card has been installed, you
need to remove the option card before
installing the firmware card.
1
Remove the system board access
cover (see page 29).
2
Unpack the firmware card.
Avoid touching the metal pins on
the bottom of the card. Save the
packaging.
3
Holding the card by its sides, align
the pins on the card with the holes
on the system board.
4
Push the firmware card firmly into
place.
The entire length of the connector
on the firmware card must touch
and be flush against the system
board.
Be careful not to damage the
connectors.
33