Complete The Installation - Kohler K-819 Installation Manual

Check for level.

5. Complete the Installation

CAUTION: Risk of property damage. A watertight seal must exist on all bath drain connections.
The watertight seal will prevent property damage.
NOTE: When installed, the base trim accessories are designed to leave a 1/8" (3 mm) gap between a level
finished floor and the accessory. This gap allows access to the adjustable feet for leveling the bath.
Connect the Plumbing
Connect the trap to the drain.
Install the bath faucet according to the faucet manufacturer's instructions.
Open the hot and cold water supplies. Check all connections for leaks.
Run water into the bath. Check the drain connections for leaks.
Level the Bath
Lift the float to access the leveling bolts at the bottom of the four adjustable feet.
Using the wrench provided, turn the leveling bolts to adjust the height.
Verify the bath is: (1) level across the top of the bath, (2) plumb along the drain side, and (3) resting
on all four feet.
Level the Float
Lift the float and turn the leveling bolts with your fingers. Adjust the four leveling bolts until
spacing between the bath and the float is uniform around the entire bath.
Kohler Co.
1/8"
(3 mm)
Gap
Finished Floor
Float
7
Leveling
Bolt
Wrench
1143194-2-A