Scs Debug Trace - Lexmark X644E User Manual

I :
MPORTANT
Unless you have a computer running a capture
program attached to the selected port to receive
the trace data, the printer will remain Ready and
may not complete establishing a session with the
host.
Operations - Common Setup: SCS Debug Trace
SCS Debug
The trace function traces all input (EBCDIC) and output (ASCII)
Trace
data.
The trace menu option allows you to enable tracing and choose
where the trace data should be sent.
Because tracing will decrease printing performance, it should only
be enabled when needed by service personnel for troubleshooting
and service.
N
N
: If the SCS/TNe Emulation is set to make an IDB dump when
OTE
this option is enabled (
command), then the IDB dump is ignored and NOT
produced. The trace function also overrides the
Hex Dump and SCS5250 Hex Dump
: If the Download Font (IDB Option 244)
OTE
a TN5250e session, the fonts will be output in the trace data
before the job is processed. This decreases trace
performance significantly. It is recommended to set the
Download Font (IDB Option 244)
performing a trace.
or
&%IDB_PRINT &%IDB_PRINT_FULL
options.
option is Enabled on
option to Disabled when
SCS3270
80