Table of Contents
Advertisement
Service Information TV 03/01
3. Volume adjustment:
You can store a volume setting deviating from the basic volume separately for every
programme position in the „Sound" menu (blue button) under the menu item „Volume
adjustment". This adjustment is allowed by the software only if the basic volume is higher than
7 of the 64 steps of the control range.
4. Picture settings (brightness, contrast, colour, etc.):
The desired picture settings are carried out in the „Picture" menu (red button). Changing the
contrast is only possible with the „manual" presetting. The presettings „During the day" and „In
the evening" are stored with fixed contrast settings. To get a better overview, it is possible to
reduce the large menu scale after selecting the desired menu item by pressing the „OK"
button. In doing so, more menu content is visible and the setting, e.g. colour contrast, is highly
facilitated.
5. Sat radio (only with satellite retrofit kit SER 300A):
Via the menu guide „i" -> „Infothek" -> „Sat-Radio", about 40 pre-stored sat radio stations can
be called up (dark picture screen, only the station name is visible). In this operating mode, the
programme table can be displayed after pressing the „i" button in order to select/change the
sat radio stations.
6. Time and date:
Each time the set is powered on, the internal software clock is set when receiving a station
broadcasting Teletext.
If only stations without Teletext are received after power on, no clock time can be called up. In
this case, the clock and time can manually be set via „i" -> „Installation" -> „Time and date".
7. AV settings:
The sets with the chassis Digi 100 provide the possibility of individually configuring all
available AV programme positions. The factory settings are:
AV 1 for the connection of a Megalogic video recorder,
AV 2 for the connection of a DVD player (via RGB),
AV 3 (if available) for the connection of a VHS video recorder (a switching voltage is
necessary at the Euro-AV socket Pin 8),
AV 4 for the connection of a VHS camera.
If you wish to change these presettings, you can individually configure all AV connections via
„i" -> „Installation" -> „Connections" . In this menu, various units are preset which can be
activated if they are required. A connection diagram can be displayed by pressing the yellow
button.
In addition own unit profiles can be created via the menu item „Manual AV settings". These
unit profiles are indicated with „manual" in the connection diagram. Please note that settings in
the „Manual AV settings" must correctly be effected in any case, and that preset units at AV 1,
AV 2 etc. are deactivated at the same time (see connection diagram). For example, an
incorrectly set time constant would result in a black/white picture with a VCR signal source.
2/2
Advertisement
Table of Contents
