Flash Programming For The New Digi 100 Generation - Grundig Digi 100 Manual

Service Information
Gerät:
Colour TV sets Digi 100

Flash programming for the new Digi 100 generation

For the above stated series of sets, no completely programmed EPROM has
been used for the device software. The software is stored in a Flash-Eprom that
can be externally loaded. In this way it is possible to update the software with-
out opening the housing of the TV set.
To do this, the new software is downloaded into the TV set via the serial inter-
face of a PC and the programming socket located at the rear of the TV set using
a download programme and a RS232 converter (Flash-Programmer F-Prog 1).
Required equipment
Flash-Programmer F-Prog 1, part no. 759880740000
Required hardware (minimum)
- PC with processor 486/66 and operating system Windows Version 3.11 or
higher
- 8 MB free main memory
- Free fixed disk capacity of 20 MB
- Internet access or InfoTip-System
Calling up the current device software
The software can be called up from a protected area of the Grundig Internet
Homepage after entering your customer number and a password, or it can be
called up via the InfoTip-System (under „Service Tips").
Example for calling up the software from the Internet:
- Start the Microsoft Internet Explorer or Netscape Navigator.
- Enter http://www.grundig.com and confirm.
- Click to Info + Products on the Grundig Home-Page.
- Position the mouse pointer to Service.
- Click to Reseller Support.
420710000 (8002/8012, 8005/8015)
Returns
analysis
1/1