Table of Contents
Advertisement
Service Information
Setting hints and special functions (options) for the colour TV sets with
the chassis Digi 100 (CUC 1807, 1837, 1838, 1839, 1934, 1935)
e.g.: Elegance 70 M 70-300 Dolby, Elegance 70 MW 70-150/8 Dolby,
Hamburg SE 8240 Dolby, M84-212/8 Dolby, Toronto SE 7216 Dolby
Below you find setting hints and explanations for various functions of the TV
sets with the chassis Digi 100.
1. Power-on behaviour of the set
In the „Special functions" menu you can select under the „Power on" menu
item between „automatic" and „Programme position 1" .
automatic: the set is switched on with the last power-on mode. For this, the
last recognized programme position and operating mode (standby or
normal operating mode) are stored.
Note: if the set has been switched off with the mains button in standby
mode, it goes again in standby mode after power on and must
definitely be switched on using the remote control.
Programme position 1: the set selects programme position 1 each time it is
switched on.
2. Settings in the „Programme table" menu
In this menu, further presettings can be programmed in addition to the
channel setting for every programme position.
Note: direct channel entry is only possible in the programme table.
„P+" reversion point: the reversion point is the limitation of the programme
positions for programme selection using the „P+" button. This
reversion point is marked with an orange line in the programme table.
To shift the reversion point, it is necessary to shift the programme
position above or below this line according to the direction of shift.
1-/2-/3- digit programme position selection (3-digit only with a retrofitted
satellite module): for 1-digit programme position selection you must
place the reversion point in the programme table between the
programme positions 1 and 10. For 2-digit programme position
selection place the reversion point between the positions 10 and 100.
Forced settings (forced colour standard, forced mono, fixed assignment of a
multi-channel sound, RF time constant, AFC):
In the „Channel settings" menu (menu guide: „i" -> „Programme table"
-> „Edit" -> „Change channel settings") you can carry out various
forced settings.
Note: it is also possible to set a forced colour standard for the AV
programme positions in this menu.
4121100000 (8002/8012, 8005/8015)
Returns
analysis
1/2
Advertisement
Table of Contents
