Table of Contents
Advertisement
Remove the 3 bolt hole knockouts and the ¾" T.S. conduit knockout on the mating sides between the two packs. Bolt packs together with ¼" bolts, internal-
tooth lockwashers (one under bolt head and one under nut), and nuts (not supplied). Bush control wire knockout with ¾" T.S. chase nipple or equivalent (not
supplied).
• Fasten packs to wall with appropriate fasteners.
Note: Two fully loaded packs weigh 80 pounds (36.2 Kg.), not including wire weight.
Packs mounted to Unistrut supports:
Note: If more than two packs are mounted together the mounting holes are no longer on 16" centers.
• Using the dimensions shown in Figure 1 mark the wall with the locations of two horizontal mounting channels.
• Fasten two mounting channels, Unistrut P3300T or equivalent (not supplied), to the wall at each vertical stud or framing member.
• Insert Unistrut nuts (not supplied) on 14" (356mm) centers in each channel for each pack section to be mounted.
• Remove the 3 bolt hole knockouts and the ¾" T.S. conduit knockout on the mating sides between adjacent packs. Bolt packs together with ¼" bolts, internal-tooth
lockwashers (one under bolt head and one under nut), and nuts (not supplied). Bush control wire knockout with ¾" T.S. chase nipple or equivalent (not supplied).
- Mount the pack assembly to the mounting channels using bolts and lockwashers.
Semi-Recessed Packs:
• Locate semi-recessed mounting kit, Model Number 600-906 (shipped separately).
• Mount the two mounting brackets to the sides of the pack with the 10-24 screws and lockwashers supplied. Refer to Figure 2.
• Mount the pack in the wall to two studs or other suitable structure with #12 flat head wood screws (not supplied) or other suitable fastener. Adjust the mounting
brackets if necessary to make sure the back of the black extrusion is at least 1/8" (3.175 mm) in front of the finish wall surface.
- Skip to Step 3 for conduit installation instructions and then return to this step.
- Attach the two vertical parts (countersunk holes) of the trim frame to one of the horizontal parts (tapped holes) with 2 black flat-head 6 - 32 screws (supplied).
- Set the other horizontal trim frame part in place on top of the cabinet behind the blower grill.
- Install the pre-assembled trim frame from the bottom of the pack and screw to the top part with the remaining screws. If frame fits loosely, bend the tabs provided in
the vertical parts with pliers to press against pack wall.
Figure 2 - Semi Recessed Mounting Dimensions
Page 2
Advertisement
Table of Contents
