Download Print this page

Components - Ford BRONCO 2023 Quick Reference Manual

Advertisement

RE MOVAB L E V EHI CL E CO M P O N E N TS
Additional information including important warnings, precautions and step-by-step instructions can be found in the Removable
Vehicle Components chapter of your Owner's Manual.
RE M OVA BL E W I ND OWS *
SOFT TO P VE HIC L E R EA R QUA RT E R W I ND OWS
1. Release the rear edge of the panel by pulling the fabric out of
the slot.
2. Unbuckle the three clips at the top.
3. Release the front edge of the panel by pulling the fabric out of
the slot to remove.
4. Slide the bottom panel forward out of the slot to remove.
To install the rear quarter window, perform the steps above in
reverse order. When installing the rear quarter windows, make
sure the window is tucked under the tension cable. After
installing the rear quarter windows, press along the top of the
window to secure the hook and loop fastener strips.
SOFT TO P VE HIC L E R EA R WI NDOW
1. Open the tailgate.
2. Release the hook and loop fastener strip along the top of the
rear window and flip the fabric upward.
3. Tap both bottom corners of the rear window rearward to
disengage the clips. Do not pull on the fabric from the top or
bottom corners.
4. Remove the top corners from the slots.
5. Unbuckle the four clips at the top.
6. Slide the bottom out of the slot left or right to remove.
To install the rear window, perform the above steps in reverse
order. After installing the rear window, press along the top of the
window to secure the hook and loop fastener strips.
H AR D TO P VEHI CLE REA R QUA RT ER W I N DOWS
1. Lift the latch to release the rear quarter window. The quarter
window opens slightly to provide access.
2. Rotate the rear quarter window while pulling down to
separate the glass from the frame.
To install the rear quarter windows, rotate the rear quarter
window into the rubber seal and push the rear glass into the
latch mechanism. The latch engages when correctly installed.
R EM OVABLE HARD TO P*
To remove the hard top, you need to remove the roof panels. If
your vehicle has four doors, it has a center roof panel.
Note: Remove the driver side front roof panel before removing
any other roof panel.
To remove the driver side front roof panel, fold down the sun
visor against the windshield. Turn the three L-shaped locks on
the driver side front roof panel, unlocking them from the roof,
then unlatch the driver side header panel latch at the top of the
windshield. Remove the driver side front roof panel. Repeat this
process to remove the passenger side panel front. To install,
reverse the removal procedure.
If your vehicle has a center panel, you need to remove this next.
Removal of the center and rear roof panels requires two adults.
Turn the three L-shaped locks on the center roof panel,
unlocking them from the rear roof panel. Unlatch the driver side
and passenger side latches of the center roof panel and remove
the center roof panel.
PAGES
16
17
*if equipped

Advertisement

loading