Cleaning And General Care - Bushnell Elite Tactical LMSS2 Owner's Manual

Once set, the eyepiece diopter should not need further adjustment, and the eyecup can be extended again if desired. Do
not use the eyepiece diopter to focus on your subject, only to focus the reticle. Use the main focus ring if the subject is not
sharp.
ACCESSORY MOUNTING RAIL
The LMSS2 includes a Picatinny/Weaver mounting rail (F) for accessories (red dot sights, lasers, night vision, illumination,
etc.). This rail can be positioned to the user's preference on the scope's top, left side or right side. Simply remove the two
short screws from the preferred position, then attach the rail using the provided pair of long screws. Torque to 12-15 lbf*in.
HORUS VISION® TACTICAL RETICLES
Model# ET884060H has a Horus H322™ reticle, model# ET884060T has a Horus T4 (Tremor4™) reticle. The H322 reticle
is an ideal parallel reference when working with a shooter using a riflescope with the Horus H58™ or H59™ reticle. The T4
reticle provides a calibrated reference for riflescopes with Horus Tremor2™ or Tremor3™ reticles. Images of each reticle are
shown on the next page.
Full technical specifications and key features/facts for each reticle can be found on the Horus Vision website:
https://horusvision.com.
WATERPROOF / FOGPROOF
Getting caught in a heavy downpour of rain with your spotter won't be a problem. Elite Tactical LMSS2 spotting scopes are
manufactured and tested to withstand water exposure to IPX7 standards. Fogproof protection is achieved from dry argon
gas purging that displaces all internal air, which can retain moisture.
All exterior lens surfaces have our new EXO Barrier™ coating (in addition to full multi-coating). EXO Barrier, quite simply,
is the best protective lens coating technology Bushnell has ever developed. Added at the end of the coating process, EXO
Barrier molecularly bonds to the lens and fills the microscopic pores in the glass. The result is an ultra-slick coating that repels
water, oil, fog, dust and debris - rain, snow, fingerprints and dirt will not stick. EXO Barrier is built to last: the bonded coating
will not fade with the passage of time or normal wear and tear.

CLEANING AND GENERAL CARE

The lenses of your Bushnell Elite Tactical LMSS2 spotting scope are fully multi-coated for highest light transmission. As with
any multi-coated optics, special care must be taken in cleaning the lenses. Follow these tips for proper lens cleaning:
• Blow away any dust or debris on the lens (or use a soft lens brush).
• To remove dirt or finger prints, clean with the supplied micro-fiber cloth rubbing in a circular motion. Use of a coarse
cloth or unnecessary rubbing may scratch the lens surface and eventually cause permanent damage. The included
washable microfiber cleaning cloth is ideal for the routine cleaning of your optics. Simply breathe lightly on the lens to
provide a slight amount of moisture, then gently rub the lens with the microfiber cloth.
• For a more thorough cleaning, photographic lens tissue and photographic-type lens cleaning fluid or isopropyl alcohol
may be used. Always apply the fluid to the cleaning cloth – never directly on the lens.
Never disassemble your spotting scope. Irreparable damage can result from unauthorized service attempts, which also void
the warranty.
H322 and Tremor4 are trademarks of Horus Vision Reticle Technologies
Technical Specifications
ET884060H 8-40x
ET884060T 8-40x
Both Models: ED Prime objective lens, Fully multi-coated optics, with EXO Barrier™ on exterior lens surfaces.
60 MM H322 250 ft /83m @8x
50 ft/17m @40x
60 MM Tremor4 250 ft /83m @8x
50 ft/17m @40x
5.0/1.5 30 30
5.0/1.5 30 30
12.7/323 37.1 / 1053
12.7/323 37.1 / 1053
3