Separation Of Display/Gc-08; Separation Of Display; Attachment Of Gc-08 - A&D GC Series Instruction Manual

18.3. Separation of Display/GC-08

The display can be separated from the main scale. The length of cable between the display and the scale is
approximately 1 m. With the GC-08 (extension cable), the length can be extended up to 2 m.
If the operation is done with the weighing pan facing downward, excessive force will be placed on the
scale, which may cause damage.
To reattach the display after separating it, attach it to the main scale in the reverse order.
In doing so, be careful not to get the cable caught between the devices.

18.3.1. Separation of Display

1. Remove the power source from the scale.
2. Loosen the four screws from the bottom of
the base and remove the cover.
3. Loosen the four screws and remove the display
and its securing sheet.

18.3.2. Attachment of GC-08

1. Remove the display (refer to
2. Remove the cable clamp from the bottom of the base and
remove the cable.
3. Open the cable panel of display and remove the connector.
Squeeze the cable bush on the cable panel from both
sides and remove it from the cable panel.
4. Attach the option cable (GC-08) together with the cable bush
to the cable panel the same way as the standard cable.
5. Attach the connectors of the option cable (GC-08) to the
display and the base respectively. After attaching the
connector to the base, secure the base with cable clamp.
Firmly attach the connector in the correct direction.
Poor connection may prevent accurate weighing.
"18.3.1. Separation of Display").
72
Cover
Display securing sheet
Cable panel
Cable bush