Diagnosing Problems Using Pc-Doctor From The Service Partition; Troubleshooting; Error Messages - Lenovo ThinkPad X60 Tablet 6363 Supplementary Manual

Solving computer problems
4. Using cursor keys, select HDD diagnostic program. Press Enter.
5. Using cursor keys, select Main hard disk drive or Ultrabay hard disk
drive.
6. Press Enter to start the diagnostic program.

Diagnosing problems using PC-Doctor from the service partition

By using PC-Doctor from the Rescue and Recovery workspace in the service
partition of the hard disk drive, you can diagnose your system without
starting up the operating system. Do as follows:
1. If the diskette drive is connected to the computer, remove any diskette
from the diskette drive, and then turn off the computer.
2. Turn on the computer.
3. While the message, "To interrupt normal startup, press the blue
ThinkVantage button," is displayed at the lower left of the screen, press
the blue ThinkVantage button to enter the Rescue and Recovery
workspace.
4. Select Diagnose hardware. The computer restarts and PC-Doctor starts up.
For more information about PC-Doctor, press F1 to go to the Help or online
manual for the program by pressing F1.

Troubleshooting

If you do not find your problem here, see Access Help. The following section
only describes problems that might prevent you from accessing this help
system.

Error messages

Notes:
1. In the charts, x can be any character.
2. The version of PC-Doctor referred to here is PC-Doctor for Windows.
Message
0176: System
Security - The
System has been
tampered with.
0182: Bad CRC2.
Enter BIOS Setup
and load Setup
defaults.
12
®
ThinkPad X60 Tablet Service and Troubleshooting Guide
Solution
This message is displayed if you remove the Security Chip and
reinstall it, or install a new one. To clear the error, enter the
BIOS Setup Utility, press F9 to set values to default, then press
F10 to save changes. If this does not solve the problem, have
the computer serviced.
Checksum of the CRC2 setting in the EEPROM is not correct.
Press F1 to go to BIOS Setup Utility. Press F9 and then Enter to
load the default setting. Press F10 and then Enter to restart the
system.