Trane CXAO Installation Operation & Maintenance page 33

Filter oil
The compressors are equipped with an oil fi lter fl ange
directly into the oil sump.The fi lter with fi lter element
easily Replaceable, has a high effi ciency and a pressure
drop below 0.6 bar
Pressostato differenziale
che consente di monitorare la
funzionalità del fi ltro (opzione)
Lubricating oil
The lubricating oil shall be:
• Good viscosity characteristics at high
temperatures;
• Good miscibility with the refrigerant at low
temperatures;
The compressors CX can be loaded with the following oil
lubricants approved by the manufacturer:
Lubricating oil
The lubricating oil shall be:
• Good viscosity characteristics at high
temperatures;
• Good miscibility with the refrigerant at low
temperatures;
The compressors CX can be loaded with the following oil
lubricants approved by the manufacturer:
POE UNIQUEMA RL170H
POE CASTROL ICEMATIC SW170
POE CPA SOLEST 170
POE FUCS RENISO TRITON SA170
POE MOBIL EAL ARTIC 170
POE FRASCOLD FC170
Oil heater
The compressors are equipped with a resistance tube
inserted into a well made in the fusion
The heating oil has the aim to prevent excessive dilution
of the refrigerant in the oil.
• The resistance is already thermostated and
not need to be interfaced with the compressor
contactor.
RF-SVX003A-GB
Filtro olio
Elemento fi ltramte
facllmente sostituiblle
POE UNIQUEMA RL170H
POE CASTROL ICEMATIC SW170
POE CPA SOLEST 170
POE FUCS RENISO TRITON SA170
POE MOBIL EAL ARTIC 170
POE FRASCOLD FC170
Resisitenza di riscaldamento olio
The resistor is already installed at the factory
• Power 300 Watt
• Power 230-1-50/60 (others on request)
• Calibration thermostated 70 °C (optimal
temperature oil)
Oil compressor load
33