Minimum And Maximum Temperatures - La Crosse Technology WS-7213U Instruction Manual

4.
Replace cover.
B.
INDOOR WEATHER STATION
Note: After the batteries are installed, DO NOT press any buttons for 15 minutes. This may interfere with the signals, causing temperatures to
register incorrectly.
1.
Remove the battery cover on the backside. To do this, push up and pull out.
2.
Observing the correct polarity, install 2 AA batteries.
3.
Replace battery cover.
4.
Wait 15 minutes or until both the indoor and outdoor temperatures are shown on the indoor weather station.
5.
The indoor weather station should now show: "-:- -" in the TIME LCD, indoor temperature in the INDOOR LCD and outdoor temperature and
humidity in the OUTDOOR LCD.
Battery cover
Battery
Compartment
II.
SETTING THE TIME
1.
Press and hold the "SET" button for 5 seconds.
2.
The hour will begin to flash.
3.
Press and release the "+" button to advance the hour to your desired hour.
4.
Press and release the "SET" button to move to the minute setting.
5.
The minutes will begin to flash.
6.
Press and release the "+" button to set the minutes.
7.
Press and release the "SET" button to activate the clock.
Note: There is "PM" displayed to the left of the hour when between noon and midnight. During the AM hours this area will be blank.
FEATURES
A.

MINIMUM AND MAXIMUM TEMPERATURES

1.
Press and release the "MIN/MAX" button, "MAX" appears at the bottom of the display and the
recorded maximum temperatures are displayed.
2.
Press and release the "MIN/MAX" button to toggle to the minimum temperatures, "MIN" appears at the
bottom of the display and the recorded minimum temperatures are displayed.
B.
RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES
To reset both the minimum and maximum temperatures—press and hold the "MIN/MAX" button for 5 seconds.
C.
WEATHER FORECAST
The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time.
The WS-7213U averages past air-pressure readings to provide an accurate forecast—creating a necessity to disregard all weather forecasting for
12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e. from one floor of a building to another floor). In
areas where the weather is not affected by the change of air pressure, this feature will be less accurate.