Table of Contents
Advertisement
Installation
Flush Mount- see Fig. 9 & 10
CAUTION: Two people will be required for various steps of this procedure.
1. Prepare a wall with a framed opening for the correct model (Fig. 9)
• 34" Model: 83.8cm wide x 47cm high
• 50" Model : 124.5cm wide x 47cm high
• 74" Model: 185.4cm wide x 47cm high
!
NOTE: It is recommended that the bottom of the unit not be mounted higher than
102cm from the ground to maintain an optimized viewing angle of the flame.
WARNING: Do not attempt to wire your own new outlets or circuits. To reduce the risk
of fire, electric shock or injury to persons, always use a licensed electrician.
WARNING: Ensure that the circuit on which the fireplace is to be installed has the
power cut off at the service panel until installation is complete.
2. Lift fireplace and insert into opening. The fireplace's mounting trim should be flush
against the wall (Fig. 10).
3. Use the supplied spirit level to level the fireplace within the framing, adjust as
required.
4. Drive four supplied mounting screws through the four mounting holes located on the
inside surface of the fireplace chassis, into wall studs (Fig. 10).
5. Refer to Front Glass Installation section for final installation procedures.
Operation
User Modes:
Mode Name /
Description
Change Celsius
(
C) to Fahrenheit
0
(
F)
0
Disable / Enable
Heat Options
14
Action (Actions cannot be input by remote control)
Press both 3 Dot Button ( ) and 2 Dot ( ) on the unit and hold
until beep is heard and display flashes. (To revert back to Celsius
repeat this action)
Hold both 1 Dot Button ( ) and Flame Button ( ), on the unit, for
2 seconds, when the heater has been disabled the display will read
"--" and beep. To enable heat repeat this action.
Advertisement
Table of Contents
