Disabling Compatibility Mode - Extron electronics FOX3 Matrix Series Setup Manual

If connecting through the rear panel IPCP LAN port, enter the FOX3 Matrix IP Address/Hostname and Password in the
Target Device panel (see figure 11,
a. Select the Enable Indirect Connection checkbox (
is enabled.
Enter the IPCP Pro Matrix Q xi control card IP Address/Hostname and Password in the IP Link Pro Control
b.
Processor with AV LAN panel.
The default IP address for the IPCP Pro Matrix Q xi control card LAN port is 192.168.253.250.
NOTE:
3. Click Connect ( 5
). The FOX3 Matrix PCS main page opens (see figure 12).
Figure 12.
FOX3 Matrix PCS Main Page
To edit the IP address:
1. Click on the Edit button (see figure 10,
Communication Settings box opens.
2. Click in the field to edit (see figure 13).
3. Click Apply to complete and close.
Alternatively, click Apply and Connect to complete and connect
to the device.
Click Cancel to close the box without changes.
Internal Web Pages
Another way to configure and operate the switcher is via its factory-installed internal web pages. The pre-loaded web pages on
the switcher are accessible through the LAN port (see figure 2,
USB config port (see figure 7,

Disabling Compatibility Mode

The internal web page does not support compatibility mode in Microsoft Internet Explorer.
To check compatibility view settings:
From the Tools menu of the browser, select Compatibility View Settings. The Compatibility View Settings dialog box
1.
opens.
2.
Be sure the Display all websites in Compatibility View checkbox is clear, and the IP address of the matrix is not in the
list of websites that have been added to Compatibility View.
2
on page 10).
3
on page 10). The
A
on page 6) using a web browser such as Microsoft
3 ). The IP Link Pro Control Processor with AV LAN panel (
Figure 13.
C
on page 2) via a LAN or WAN connection or the front panel
® Internet Explorer
Communication Settings Box
® .
4
)
11