Fact - False Alarm Control And Test; Selectable Starter/Ignition Interrupt; How To Interpret The Led Status Indicator; Automatic Battery-Saving Mode - Clifford XL4000 Owner's Manual

Vehicle security/convenience system
Table of Contents

Advertisement

FACT™— False Alarm Control and Test
With FACT, you'll never experience repeated false alarms. If the Insignia Siren goes off,
DO NOT remotely disarm the system; allow it to run for the full siren duration. Before
sounding the siren a second time, the system automatically checks for another activated
trigger to verify that an intrusion is in progress. Should the siren sound again, you will
know for sure that someone is tampering with your vehicle. (To disable FACT, see
User-selectable features on pages 20-24.)

Selectable starter/ignition interrupt

At the time of installation, you can select whether your XL4000 interrupts the starter line
or the ignition line. To verify which line is electronically interrupted, enter the vehicle,
close the doors, arm the system while inside the vehicle, then try to start the engine. If
the engine cranks but does not start, the ignition is bypassed. If it does not crank at all,
the starter is disabled.
In addition, the starter/ignition interrupt will be set in either Fault-Proof mode, which
lets you start the engine even in the unlikely event of a complete system failure, or
Super-Security mode that ensures a thief won't be able to start the engine even if he cuts
all the wires or finds the system control unit and disconnects it.
Changing the mode requires a minor relay wiring change and installer-only
programming. Your local Authorized Clifford Dealer can make the changes for you.

How to interpret the LED status indicator

The LED on your car's dashboard or console will inform you of the system status:
LED Condition
Off
On
Valet mode is on, the vehicle can be driven or serviced without having to disarm
Flashing
Pause between flashes
Either a malfunction (see page 17) or an intrusion was attempted (see page 18)

Automatic Battery-Saving Mode

To conserve vehicle battery power (the LED draws more current than the entire control
unit), if the system has remained continuously armed for 48 hours, the flash rate will
automatically slow to half the normal rate. After 96 hours, it slows to one-quarter.

AutoLock and AutoUnLock™

For your safety and that of your passengers, the doors automatically lock the instant you
turn on the ignition (see User-selectable features on pages 20-24). When you turn the
ignition off, AutoUnLock automatically unlocks the doors. To suit your preferences, you
may turn off either or both the AutoLock and/or AutoUnLock features. There are four
possibilities: AutoLock "on" while AutoUnLock is "off", or vice-versa. The other two
combinations are both AutoLock and AutoUnLock "on" or both "off."
Meaning
System is disarmed and in normal operating mode (i.e., valet mode is off)
System is armed and protecting your vehicle
16

Advertisement

Table of Contents
loading

Table of Contents