STA-RITE SR200NA Service Manual page 36

SECTION FOUR – Routine Maintenance and Professional Servicing
Thermistor
L L L L o o o o c c c c a a a a t t t t i i i i o o o o n n n n
The Thermistor is located in the uppermost well of the
Manifold under the left-hand Switch Cover.
F F F F u u u u n n n n c c c c t t t t i i i i o o o o n n n n
The Thermistor monitors the inlet water temperature.
S S S S e e e e r r r r v v v v i i i i c c c c i i i i n n n n g g g g P P P P r r r r o o o o c c c c e e e e d d d d u u u u r r r r e e e e
To check the Thermistor:
An open Thermistor displays E01 on the control board.
Ashorted Thermistor displays E02.
To replace the Thermistor:
1. Turn off the filter pump and all electrical power to
the heater.
2. If the heater is below the pool water level, close iso-
lation valves to avoid draining the pool.
N T
V E
S
E S
P R
B
TA
O T
P IL
3. Remove the Drain Plug under the Manifold to drain
the heater.
4. Unbolt and remove upper left and upper right jack-
ets to expose the Operating Control Assembly and
the Manifold Switch Cover.
5. Remove the Operating Control Assembly
(See Page 4-2).
6. Disconnect the Thermistor wires on the Control
Board (Connector J5).
7. Remove the Manifold Switch Cover.
8. Unscrew the Thermistor from the Manifold.
9. To replace the Thermistor, reverse Steps 1 through
8. Be sure to teflon tape the threads when rein-
stalling Thermistor.
4-4
Thermistor
P/N 42001-0053S
2653 1096