Parameter Setting - Siemens SIMATIC ET 200SP Equipment Manual

Parameters/address space

4.3 Parameter setting

4.3 Parameter setting
You can use various parameters to define the properties of the communications module.
Depending on the settings, not all parameters are available.
You set the parameters of the module as follows:
Parameter setting via ...
Hardware configuration in STEP 7
(TIA Portal)
Hardware configuration using GSD
file for distributed operation on
the PROFINET IO
Hardware configuration using GSD
file for distributed operation on
the PROFIBUS DP
28
Basic procedure
1. Insert the module from the hardware catalog under "Communications modules".
2. Set the parameters of the module in the hardware configuration.
3. Download the project to the CPU.
1. Install the latest PROFINET GSD file.
You will then find the module in the hardware catalog under "Other field devices >
PROFINET IO > I/O".
2. Set the parameters in the hardware configuration.
3. Download the project to the CPU.
1. Install the latest PROFIBUS GSD file.
You will then find the module in the hardware catalog under "Other field devices >
PROFIBUS DP > I/O".
2. Set the parameters in the hardware configuration.
Only the parameters marked with
PROFIBUS GSD file.
3. Download the project to the CPU.
The parameters that are not marked with
with their default setting.
4. If necessary, set the parameters not marked with
corresponding data records.
in the following table can be set in the
1
in the following table are downloaded
1
in the user program using the
1
CM PtP communications module (6ES7137-6AA01-0BA0)
Equipment Manual, 03/2021, A5E03790792-01